Specifications
Material
Mounting
Hole pitch
Backlash
Footprint
M10 1.5 mm pitch
Delrin (acetal)
2 hole fixing
20 mm
Zero (pre-set screw adjustment)
13 mm
Description
This nut block has been designed specifically for the CNC hobbyist in mind, to provide a low cost solution for providing linear motion when coupled with a standard M10 screw thread and stepper motor.
This particular item comprises of a delrin anti-backlash nut block with a standard M10 1.5 mm pitch.
This pitch is ideal for small hobby CNC machines, where large speeds are not required, as the fine pitch provides good precision whilst requiring minimal force from a stepper motor, and thus is suitable for direct drive with small stepper motors. Due to the high resolution(0.0075 mm per full step on a standard 1.8 degree motor) vibration is negligable and a simple drive can be used without micro-stepping, thus further reducing cost.
The anti-backlash delrin nut is manufactured from grade A delrin (acetal-homopolymer B) supplied from a reputable European manufacturer. This material is extremely hard wearing, and normally does not require lubrication. A pre-set screw adjustment removes any backlash, and due to its mechanical properties there is minimum friction and wear.
For best performance the screw thread should be polished stainless steel, in order to minimize friction and wear.
The form of the nut is as a rectangular block with 2 mounting holes, and as such can be directly attached to the moving base, without need for brackets or additional items.
This item is shipped by registered international air mail